42VQV
GB - 9
E N G L I S H
Use of the remote control
(Cooling only or dehumidification)
(Heating)
SET
TEMP.
SET
TEMP.
SET TIME
SET TIME
TIME (MIN.)
TIME (MIN.)
PM
PM
PM
AM
PM
PM
PM
+0.5
°
C
+0.5
°
C
+0.5
°
C
+0.5
°
C
°
C
30 70 110 150
-1
°
C
°
C
30 90 150
-1
°
C
-1
°
C
PM
A
B
1
2
A
B
1
2
DAILY timer
(Everyday - button J)
Push the button
when the ON or OFF timer is active. The icon
will appear on display.
In this way the ON and OFF timer memorization will be repeated
every day.
To disactivate the daily function, press again the button
.
Combination of ON, OFF and DAILY timer
procedure
If you want operation to start at 5.30 P.M. and stop at 10.30 P.M.,
proceed as follows:
1.
Select ON timer at 5:30 P.M.
2.
Select OFF timer at 10:30 P.M.
3.
Select the desired operating mode (button
).
If you want to stop operation at 10:30 P.M. and start again at 7:30
A.M. with the same operating mode, proceed as follows:
1.
Select OFF timer at 10:30 P.M. during operation
2.
Select ON timer at 7:30 A.M.
If you want Everyday operation to start at 5.30 P.M. and stop at
10.30 P.M., proceed as follows:
1.
Select ON timer at 5:30 P.M.
2.
Select OFF timer at 10:30 P.M.
3.
Press the Everyday button (daily button
).
Cancellation of ON, OFF and DAILY timer
procedure
1.
If you want to cancel On or OFF timer
setting, press the following buttons in
sequence:
• button
or
;
• button .
To deactivate the Everyday function, press
button
.
The Everyday function will remain operative
until one of the two timers (ON or OFF) is
active.
Address selector (Ab)
If you have two indoor units in the same room, you can link one
remote control to one indoor unit, and the other remote control to
the other indoor unit, or you can control both indoor units with a
single remote control.
For configuration, refer to the installation manual.
Sleep timer procedure “night”
(button M)
Press this button to set the SLEEP timer with remote control on.
The icon will appear on the display.
This procedure permits setting the remaining unit operating time.
1.
“1:hr” will be displayed together with the
icon.
2.
Press button
(temperature increase).
The display will show the following settings
in sequence:
1 hr, 2 hr, 3 hr, 4 hr, 5 hr, 6 hr, 7 hr and 9 hr.
3.
Once the remaining operating hours have
been selected with either button
or
,
again press button
to confirm.
4.
When the SLEEP timer is set, the unit will
control the set temperature to avoid
overcooling or overheating during operation.
The set temperature will change as follows:
