![background image](http://html1.mh-extra.com/html/carrier/42uqv050m-series/42uqv050m-series_service-manual_2560903053.webp)
FILE NO. SVM-13035
CAUTION
• Be sure to refer to the wiring system diagram
labeled inside the front panel.
• Check local electrical cords and also any specific
wiring instructions or limitations.
CAUTION
Earth line
20 mm
10 mm
80 mm
110 mm
1
2
3
Cord clamp
Terminal block
Terminal cover
Screw
Earth line
Screw
Connecting cable
Stripping length of the connecting cable
NOTE :
•
Use stranded wire only.
•
Wire type : H07RN-F or 60245 IEC66)
Fig. 10-3-7
(1.0 mm
2
or more)
Connecting Cable
abou
t 15 c
m
Fig. 10-3-6
Fig. 10-3-8
Fig. 10-3-9
Display unit
Display board
2 3
Remove screw
Indoor unit
Control wire
Remote controller
Air inlet grille
Front panel
1
3
1
2
10-3-5. How to Connect Remote Controller
for Wire Operation
<For indoor unit>
1. Open the air inlet grille upward.
3. Slightly open the iower part of the front panel thon
pull the upper part of the front toward you to remove
it from the rear plate as shown on figure
.
4. After removing the front panel, remove the screws
and Display unit from the unit as shown on figure
2
then open the front cover of Display unit as shown
on figure
.
1
3
2. Securely remove four screws at the front panel.
5. Arrange the control wire as detail and specification
as shown on figure
.
6. Securely connect the control wire to terminal of
display unit board as shown on figure
(tighten
firmly but not over : 0.12 N·m (0.01 kgf·m).
7. Set the control wire throughout at slot on front cover
of display unit then reassembly display with main
casing by reverse process of figure
and
.
Make sure the control wire must not be pressed
by front and rear cover of display unit.
8. Set the control wire out from indoor unit same
5
4
2
3
portion as power supply and connecting cable as
shown on figure
.
9. Reassembly the indoor unit by reverse process
6
of 1
to
3.
–
52
–
Summary of Contents for 42UQV050M Series
Page 106: ...TOSHIBA CARRIER THAILAND CO LTD...