Carrier 42TVCA010, Installation Manual

Page: 10 / 40

8
Piping and Drain Hose Installation
• Since dewing results in a machine trouble, make sure to insulate both
connecting pipes. (Use polyethylene foam as insulating material.)
• The connection of pipes can be installed in the following directions.
Rear right
Rear left
Bottom left
Bottom right
Die-cutting
Front panel slit
Changing
drain hose
Piping preparation
• Rear right • Rear left
Drain hose
Drain hose
• Bottom right • Bottom left
Drain hose
Drain hose
Cut out
Front panel slit
Cut out
Front panel slit
1. Die-cutting Front panel slit
• Cut out the slit on the bottom left or bottom right side of the Front panel
for the bottom left or bottom right connection with a coping saw or an
equivalent tool.
2. Changing drain hose
• The factory default of the drain hose is installed on the right side.
• For bottom-leftward connection and rear leftward connection’s piping,
it is necessary to change the drain hose and drain cap.
How to cutting the Front panel
• To connect piping to the bottom side, the Front panel must be cut off.
• The front panel can be removed by removing 2 screws securing then
secure remove the front panel from the main body.
w Be careful of air inlet grill fall down that may cause of injure or part
damage.
Main body
Front panel
Screw 2 pcs.
Air inlet grille
• The marking for cutting are indicated on the inside of the Front panel in the
following positions.
350 mm 350 mm
Piping and drain hose forming
How to remove the drain hose
• Removed fi xing screw of LED set then pull out it from the main body.
• Removed 2 screws to fi x drain pan then secure remove the drain pan from
the main body.
Drain pan
Screw 2 pcs.
LED set
Screw
• The drain hose can be removed by removing the screw securing the drain
hose then secure rotate steel plate of drain hose to out of the Drain pan and
pulling out the drain hose.
Screwdriver
Screw
Steel plate of drain hose
Drain hose
How to fi x the drain hose
• To install the drain hose, insert the drain hose fi rmly until the connection part
contacts with heat insulator (foam), secure push steel plate of drain hose to
predetermined position of Drain pan then
fi x it by original screw.
Heat insulator (foam)
Drain pan
Drain hose
CAUTION
When removing or install the drain hose, be careful of any sharp edges
of steel plate. The edges can cause injuries.
CAUTION
When cutting the Front panel, be careful of cutting tools and any sharp
edges of plastic. It can cause injuries.
• Cut off the pipe exist from inside of Front panel using a coping saw or an
equivalent tool.
• The plastic burrs from the cutting process should be removed with a half
round fi le or an equivalent tool.
Coping saw
Half round fi le
01_1129850104-EN.indd 8 01_1129850104-EN.indd 8 17/12/2563 BE 10:37 17/12/2563 BE 10:37