22
13. REMOTE CONTROL INSTALLATION
13.1 HOW TO INSERT BATTERIES:
(a) Remove the cover of battery compartment at the back of the remote
control by pressing the tab toward inside, in the direction of the arrow.
(b) Mount the two-battery size AAA 1.5 Volt supplied with the remote control.
Then close the cover of the battery component.
Note:
During mounting of batteries check battery symbols (+, -) indicated in
batteries compartment.
NOTES:
1. The remote control uses two alkaline batteries (1.5V, LRO03x2).
2. Do not use used batteries or batteries of different types, as this may cause the air conditioner to
malfunction.
3. Batteries should only be changed after turning OFF the air conditioner.
4. The average battery life during normal use is approximately one year.
6. When the symbol
appears in the display of the remote control, this indicates that the
batteries are exhausted and required to be replaced
13-2 INSTRUCTION:
WHEN DIRECTING THE TRANSMITTER OF WIRELESS REMOTE CONTROL TO THE RECEIVER
OF INDOOR UNIT FROM A CERTAIN LOCATION, CHECK THE FOLLOWING POINTS:
1- Avoid direct sunlight on the receiver of indoor unit, which may interfere with good signal reception
2- No obstructions such as curtains or plants should be between the remote control and the receiver
of indoor unit.
3- The maximum operating range for the remote control is approximately 5 meters.
4- The remote control must be directed toward the receiver of indoor unit when pressing the buttons of
the desired functions. An acoustical acknowledgement sound (beep) will indicate that signal has
been received.
Summary of Contents for 42QG18-C
Page 1: ...0 2009 ...
