GB - 6
42PHQ ...P
• The piping can be connected in the four ways indicated by
,
,
and
.
When the piping is connected to points
,
or
, remove
the knock-out either at the side or at the bottom of the unit.
IMPORTANT NOTE:
This unit has no refrigerant expansion device.
Installing the wall hanging bracket
• Install the wall hanging bracket so that it is level. Use a plumb
line if necessary.
• Be sure to leave the clearance spaces. (Refer to page 3).
• If the wall hanging bracket is not level, water may drip onto the
floor.
• Install the wall hanging bracket with a fixing that is strong enough
to withstand the weight of the unit.
• Before installing the wall hanging bracket, remove it from the unit
by pushing at the indicated parts at the bottom of the body.
• Fasten the wall hanging bracket to the wall with 4 or more screw
anchors through the holes near the outer edge of the bracket.
• Install the wall hanging bracket so that there is no gap between
the bracket and the wall.
• Check that the wall hanging bracket does not move.
This can cause noise during operation.
• If the unit is removed from the wall hanging bracket after installing
it onto the wall, remove it by pushing up the indicated MARKS
(
) at the bottom of the body. (Refer to page 7).
Marking the wall penetration for the
connection piping
Rear piping
• It is best for the piping to go through the wall behind the unit, so
that the unit hides the pipes.
• For this method of installation, make a 65 mm diameter hole in the
wall at point A.
• Drill a 65 mm diameter hole at a slope so that the outside end is
lower (5 - 10 mm) than the inside end.
This will ensure good drainage.
• Cut the wall sleeve to match the wall thickness and pass the pipe
through the hole.
Side or bottom piping
• Remove the knock-out in the unit and pass the pipes through
the wall.
• The pipe should slope downward and away from the unit to
ensure good drainage.
Installation
Remove screw
Plumb line
300
min.
120 min.
450
min.
450
110
23
245
51
110
56
40
260
180
007, 009, 012, 014
53
379
899
90
71
71
196
25
53
A
155
350
018, 024
Indoor side
Outdoor side
5 ~ 10 mm lower