Programming
Occupied & Unoccupied Periods
17
PROGRAMMING NOTES
You will be prompted to enter both heat and cool setpoints even if the
thermostat is configured for heat only, or cool only.
• If only 1 Occupied period is selected, the Occupied 2 & 3 steps will be skipped.
Further, if only 2 occupieds are selected, the Occupied 3 steps will be skipped.
• Heat & Cool setpoints for Occupied 1 are the same for each day. Heat &
Cool setpoints for Occupied 2 & 3 can be adjusted differently for each day, if
desired.
•
If the start time is set for later than the stop time
, the program will
run from the start time to midnight and from midnight to the stop time
on the same day.
For example: 9:00pm start, 8:00am stop, on MTWTF. This
program will run from 12:00am MTWTF to 8:00am MTWTF and again from
9:00pm MTWTF to 12:00pm MTWTF.
• The Unoccupied settings take effect at all times when: (1) the program is
on
and (2)
the current time is outside a preset occupied period. For this
reason start and stop times aren’t necessary for unoccupied.
• If the
same
start and stop times are programmed in for an occupied
period, then it will run 24 hours.
• If one occupied period starts and stops within another occupied period, the
lower occupied # has priority. For example: If Occupied 3 is programmed
to be “on” 24 hours, and Occupied 2 is programmed to run that day, then
Occupied 2 settings will take over from Occupied 3 between Occupied 2
start and stop times.
• When the time period programming for Unoccupied is in the Override
mode (see page 12), the Heat & Cool setpoints for Occupied 1 are used.
Downloaded from
