![background image](http://html.mh-extra.com/html/carrier/33aw-cs1/33aw-cs1_installation-manual_2563976004.webp)
4
Installation
Drill two 5 mm mounting holes in wall where marked.
5.
Secure mounting base to the wall with 2 anchors and
6.
screws provided making sure all the wires extend
through hole in the mounting base.
Adjust length and routing of each wire to reach
7.
proper terminal and connector block on mounting
base with 6.5mm of extra wire. Strip only 6.5mm of
insulation from each wire to prevent adjacent wires
from shorting together when connected. See Fig. 2.
Match and connect equipment wires to proper
8.
terminals of the connector blocks (see Fig. 3).
Refer to wiring diagram (page 20) for more details.
1
2
3
Rc – Not used
Rh – Not used
W – Data In
C – Data Out
G – Unregulated 12V DC Voltage
Y – Ground
Terminal Designations
Secure Wires to
Terminal Strip
Back-plate Mounting
English