ULW Czech, s.r.o.
V Ráji 34, Praha 9
-
Hostavice, 198 00, CZ, IČO: 28256212, DIČ: CZ28256212
electrical system. One power source is included with our Carpe Iter Holder and can
also be purchased separately.
2.1.6.
Dust cap for M8 charging connector.
2.2.
Carpe Iter Holder (“
Holder
”)
for motor vehicles, especially motorcycles. The Holder is sold
in two versions
–
charging (includes a proprietary power source for the Device and pogo pin
charging connector) and non-charging. In case you decide to use non-charging version of
the Holder, CI Pad can be charged via the M8 charging cable from our proprietary power
source (power source is included with a special CI Pad set for non-charging Holder or can be
purchased separately). When this manual refers to charging via the Holder, it refers to the
charging version of the Holder.
2.3.
Holders manufactured after April 5, 2022 include brackets to retain the M8 charging cable.
Please see addendum to this manual for installation instructions.
2.4.
Pogo pin charging version of the Holder might require installation of that connector by the
user. Please see addendum to this manual for installation instructions.
3.
Before first use
3.1.
Before first use, charge the Device to 100% battery capacity with the provided USB wall
charger (this is necessary to properly calibrate the battery indicator). 100% battery capacity
is achieved, when battery voltage level indicated by the Carpe Manager - Power&Charge
exceeds 4,2V and charging current drops to approximately 500mA with LCD brightness at
it’s LOWEST setting
;
3.2.
Connect the Device to internet;
3.3.
Open pre-installed Carpe Manger app and install / update at least the following:
3.3.1.
Manager app;
3.3.2.
Controller app;
3.3.3.
GPS Tune;
4.
Controlling elements, ports
4.1.
The Device contains capacitive multi-touch enabled screen and hardware controlling
elements (buttons).
4.2.
Hardware elements description/use limitations:
