m 6370 N. Irwindale Rd. Irwindale, CA 91702 (866) 796
MC3
E
NCLOSURE
B.
Required: Provide controller computer
Our technician will install software on your Mac or Windows PC that is used to control
the turntable. Please
have a computer ready and on the network during the day of
installation. Some of the software will be registered to that computer alone, so be sure
to prepare a device that is intended to be used in the final installation to prevent
needing to authorize a
t a later date.
C.
Required: Provide and Run Ethernet to control panel location
The preferred way to join the MC3 system is to run an Ethernet cat5e cable from a
network switch to the MC3 enclosure. This can be done on a temporary basis
D.
Recommended: Provid
photography installations
The shutter release for the camera connects to the system via a thin black cable. The
end of the cable has a generic female plug. We request the model of the camera
advance
so we can supply
we will ship the camera connector at a later date.
E.
Recommended: Have an IT professional on site
installation
i.
Help get networking wired
The PLC needs to be physically wired
PC is located. Run an Ethernet cable from a switch into the port located on the outside
of the controller enclosure. A third party IT professional may be able to set up a
wireless access point to serve as a b
wirelessly.
Page
4
of
15
usa.
NCLOSURE
H
ARDWARE
M
ANUAL
Required: Provide controller computer
Our technician will install software on your Mac or Windows PC that is used to control
have a computer ready and on the network during the day of
installation. Some of the software will be registered to that computer alone, so be sure
to prepare a device that is intended to be used in the final installation to prevent
t a later date.
Required: Provide and Run Ethernet to control panel location
The preferred way to join the MC3 system is to run an Ethernet cat5e cable from a
network switch to the MC3 enclosure. This can be done on a temporary basis
Recommended: Provide advanced notice of camera model f
photography installations
The shutter release for the camera connects to the system via a thin black cable. The
end of the cable has a generic female plug. We request the model of the camera
so we can supply
the correct end fitting
at the time of installation.
we will ship the camera connector at a later date.
Recommended: Have an IT professional on site
during the day of
installation
Help get networking wired
The PLC needs to be physically wired into the same network on which your controlling
PC is located. Run an Ethernet cable from a switch into the port located on the outside
of the controller enclosure. A third party IT professional may be able to set up a
wireless access point to serve as a bridge and connect the MC3 system to the network
Our technician will install software on your Mac or Windows PC that is used to control
have a computer ready and on the network during the day of
installation. Some of the software will be registered to that computer alone, so be sure
to prepare a device that is intended to be used in the final installation to prevent
Required: Provide and Run Ethernet to control panel location
The preferred way to join the MC3 system is to run an Ethernet cat5e cable from a
network switch to the MC3 enclosure. This can be done on a temporary basis
e advanced notice of camera model f
or
The shutter release for the camera connects to the system via a thin black cable. The
end of the cable has a generic female plug. We request the model of the camera
in
at the time of installation.
Otherwise
during the day of
into the same network on which your controlling
PC is located. Run an Ethernet cable from a switch into the port located on the outside
of the controller enclosure. A third party IT professional may be able to set up a
ridge and connect the MC3 system to the network
www.carousel-usa.com
15206 Ceres Avenue
,
Fontana
CA 92
335
(866)
796-5975