caron 7340-25, Operation Manual

Page: 17 / 92

7340_7350-25-33 Series Operations Manual Rev J 3-31-21 Page 17 of 92
Connecting the Drain Line
The chamber drain connection is located in the bottom middle of the back of the
chamber. A 3/8” tube fitting, tubing and wire ties are supplied in the unit parts kit. Insert
the tube fitting into the tubing, secure tubing to fitting with provided wire tie. Insert fitting
into drain connection. Pull on the tubing after installation to make sure it is secure. Route
the drain tubing to a local floor drain. Duplicate fitting installation on other end of tubing
if necessary
If a local floor drain is not available, a variety of accessories are available through
CARON customer service. These accessories can also be viewed at
www.caronproducts.com .
For non-humidified chambers operated above 15°C, a drain is not needed. Install the
3/8” plug into the drain connection.
When using a pressurized water source, failure to connect
the unit to a drain could result in facility flooding.
The drain line relies on gravity to remove water from the
chamber. The drain line must remain below the chamber
to drain properly. Kinks or elevations in the drain line
above the cabinet drain will not allow the chamber to drain.