7
INSTALLATION
CONNECTING THE WATER SUPPLY
IMPORTANT: Product was supplied with a self adjusting sensor. The ideal sensor range for the specific location will
be set automatically.
OBJECT
Before proceeding, check that no objects are in front of the sensor
besides the washbasin.
Now, remove the protective sticker
that covers the sensor.
Connect the transformer to the transformer socket in the dual
power input box and plug it into the electricity socket.
2
Connect the four contacts connector to the dual power input box.
Important:
Make sure that the 4 contacts connector is connected
all the way through.
O-RING VISIBLE – NOT CONNECTED PROPERLY
ONLY THE GROOVES ARE VISIBLE – CONNECTED PROPERLY
3
After you have connected the four contacts connector to the dual
power input box, wait 15 seconds in order to allow the system to
set the ideal sensor range.
SECONDS
ABOUT
15
As an indication that the self adjusting has taken place a LED in the sensor eye will flash continuously. The solenoid valve
will open and close for 1 second as an indication that the ideal sensor range is set and the product is ready for use.
4
Connect flexible hose (not supplied) from the mains water supply
to the dual power input box with inlet (remove nipple and ensure
filter is refitted)
Turn on the mains water supply and check for leaks.
If the automatically adjusted sensor range is not satisfactory,
please refer to the section entitled “Settings adjustment”.
1