AUTO-i 700
60
Chapter 6:Vehicle Diagnosis
- Before starting actuation, make sure to check the operating condition to inspect
the system in the proper condition.
- The actuator time differs by the actuated items.
4. Press the Stop button to stop the actuator function.
- Press this button to stop the actuator function during diagnosis.
- Press the arrow button on the right top corner of the screen to stop
the actuator function too.
- Actuator graph mode -
5. In the figure 3-1, Press Show sensor button to see parameter data. After selecting a
parameter data, Press the graph mode button to change data value to a graph.
The actuation result is judged by noise from the running actuator or
switch and vehicle RPM change.
Therefore, it is recommended to perform the actuation test in a quiet
area and use parameter data values as a reference.
If target system does not support parameter, actuator and dual display,
it supports items of actuator without items of parameter.