EN
Maintenance - Gearbox
The gearbox is supplied factory fitted with oil and is a service free unit.
However if seals start to leak and oil level is reduced, both the affected seal and oil need to be replaced as a
general overhaul of the unit.
The unit must be removed to be drained, maintained and filled with oil.
General overhauls must only be done by authorised ATEX certified service personnel or companies.
If changing the oil place a suitable container underneath the plug for draining.
It is recommended that the oil should be warm [40-50º C] to facilitate easier draining.
After filling with fresh oil, refit the level and/or drain plugs and clean up any oil spillage.
Every 1000 hours verify the good condition of oil seals and gaskets
WARNING
Gearbox
Maintenance
Wait until the unit has cooled sufficiently after stopping and isolation.
Note:
Note:
77-3226 R5.1
30/40
www.carlisleft.com
