Dynacode II Series
Function Menu
08.16
Operating Manual
65
Adjustment of brake power for acceleration and braking in %.
Adjustment of brake power during printing.
Settings
=
Printout of all settings such as speed, and transfer
ribbon material.
Bar codes
=
Printout of all available bar code types.
Fonts
=
Printout of all available font types.
Indication of level for inputs of the IO parameters.
0 = Low
1 = High
Indication of the level for outputs of the IO parameters.
0 = Low
1 = High
The encoder values with print start in logging files are registered on
CF card. By means of this data, a graphic chart of the encoder curve
can be created.
For further information please contact our support department.
DiaRW
= Diameter of transfer ribbon rewinding roll.
DiaRU
= Diameter of transfer ribbon unwinding roll.
Number of values by which the encoder signals is averaged. The
more higher the value the more slowly react the device to speed
modifications.
Relevant results are counted and registered in RAM memory. The
protocole get lost after switching off the device.
RInt
= Real Interrupts
The start input impulses are counted directly at the Interrupt.
Dbnc
= Debounced
The start input impulses that are longer than the set debounce time
are counted. Only these start impulses can lead to a print. If a start
impulse is too short, no print is released. This is recognized by the fact
that RInt is counted, Dbnc not.
NPrn
= Not Printed
The debounced start input impulses that have not lead to a print are
counted. Causes: no active print order, print order stopped (manually
or because of an error) or the printing system ist still active with the
processing of a print order.
PrtStrtReset
= The counters are reset.
PrtStrtTime
= Measured length of the last start impulse in ms.
Brake Power
Brake Power P
Print examples
Input
Output
Diagnostic:
Encoder Profiling
Diameters of transfer
ribbon rolls
Encoder average
I/O Status
