1.
Collect the following parts:
(1) Top Wing
(1) Bottom Wing
(4) Ailerons
(16) Jet Hinges
WING CONSTRUCTION
Aileron Installation
2.
Locate the pre-cut aileron hinge slots in both
the top and the bottom wings. Using a hobby
knife (#11 blade), slide the blade into each of
the slots to make sure they are cleanly cut.
Repeat this process with the ailerons, mak-
ing sure all hinge slots are clean.
3.
Place a straight pin into the center of each of
four Jet Hinges.
3.
Slide four hinges into the hinge slots on one
side of a wing The straight pin will prevent
the hinges from going further than halfway
into the wing.
4.
Select one of the ailerons and insert the
exposed half of each hinge into the aileron
slots. Slide the aileron toward the wing until
no gap remains between the aileron and the
wing.
When satisfied with the alignment, remove
the straight pins, being sure to keep the
aileron tight to the wing. You may wish to
apply a few pieces of masking tape to keep
the pieces in place.
6.
Keeping the aileron and wing in position,
apply 3 or 4 drops of Instant thin CA to the
small exposed area of each hinge.
Turn the wing assembly over and again
apply 3 or 4 drops of thin CA to the exposed
hing surface.
Allow to dry for 10 minutes before flexing the
aileron.
7.
Repeat the above steps for each of the other
ailerons.
NOTE:
Remember that the following pictures may
not exactly match the hardware you are using.
Always check the manufacturer’s instructions when
installing radio equipment.
5.
Carefully check the alignment of the aileron,
making sure it is flush with the end of the
wing.
1.
Collect the following parts:
(1) Aileron servo door
(2) 3/8 x 3/4 x 3/4"servo mounting block
(4) 1/8 x 3/4 x 3/4 aileron door mounting plate
(4) Servo mounting screw (supplied with radio)
(4) #2 Washer
(4) #2 x 3/8" screw
(1) Servo with rubber grommet
Aileron Servo Installation (Bottom Wing)
4
Summary of Contents for ULTIMATE
Page 31: ......
