15
7.
Mount throttle servo in tray on the marks
you made earlier
Note: Your installation may vary depending
on the engine used.
Install pushrod connector on your servo
arm and attach to the throttle pushrod.
PUSHROD CONNECTOR
SNAP NUT
8.
Insert the .072 x 19” wire through the pushrod
tubing and into the pushrod connector on the
servo arm.
Make a 90 degree bend so that the wire fits
into the throttle arm on the engine. Install the
snap-r-keeper on the end of the wire.
Locate the proper positioning of the throttle
servo arm. Then cut off the excess wire, keep-
ing some wire for future adjustments.
FUEL TANK ASSEMBLY
Gather the following items
(1) fuel tank
(1) rubber tank stopper
(1) clunk
(1) 3mm x 25mm screw
(1) cap washer large
(1) cap washer small
(2) 3mm x 40mm brass tube
(1) 3mm x 60mm brass tube
(1) silicone tube 4mm x 80mm
(3) silicone tube 5mm x 165mm
1.
Insert the 3mm screw through the center
hole in the large washer, through the center
hole in the rubber washer against the large
side, and screw the small washer on the
back side.
2.
Insert the brass tubes through three of the
holes. They should be arranged so as the
long one will be on the right side of the plane
and the short one on the left side.
The tubes should extend out the front of the
cap 5/8”. Bend the long tube up at about a 20
degree angle. This should be adjusted so the
end of the tube almost touches the top of the
tank when installed.
