10
5.
Insert the 6-32 x 2” screw from the top through
the elevator.
Place the #6 washer and the 6-32 hex nut on
the bolt and tighten. Make sure that you use
thread lock on the bolt and nut.
Screw the black adjustable horn bracket on
the bolt.
6.
Thread on to each end of a 4-40 x 3-1/2”
pushrod a nut and Golden Clevis.
Mount the pushrod onto the servo and the
horn bracket.
Slide a clevis clip on to each of the Golden
Clevis pins.
Repeat the above steps for the second eleva-
tor.
RUDDER AND RUDDER CABLES
Collect the following items:
(1) 6-32 x 3” All threaded rod
(1) Black Adjustable Horn Bracket
(1) Small White Adjustable Horn
(2) 6-32 Hex Nut
(2) #6 Flat Washer
(1) Rudder
(4) Hinges
(1) Cable
(2) Brass Tubes 1/16 OD x 1/4”
(2) 2-56 Threaded Rods with holes
(2) 2-56 Golden Clevis
(2) 2-25 Hex Nut
1.
Install the hinges into the rudder and glue the
rudder in place using the same hinging
method used for the elevator and ailerons.
Position the control horn bolt so that it is 3/4”
back from hinge line and 1” up from the bot-
tom of the rudder.
Using a 9/64" drill bit, make a hole in the rud-
der.
2.
Center the 6-32 x 3” threaded rod in the hole.
Using thread lock place first the #6 washer
then the 6-32 Hex nut on each side of the rud-
der.
