11
3.
Thread the white adjustable horn on the rod
first. Insert the horn bracket far enough so that
the black horn will fit on the rod completely.
Do this for both sides of the rudder.
Insert the cable through the 1/16 OD x 1/4”
brass tubing.
Next thread the cable though the hole at the
end of the 2-56 threaded rods and loop it back
through the brass tube.
4.
Loop the end of the cable back though the
brass tube.
Next thread the cable though the hole at the
end of the 2-56 threaded rods and loop it back
through the brass tube.
Repeat steps 7 thru 10 for the other end of the
cable.
Insert the 1/8” tubing into the rear cable exit
hole. Push the tubing while guiding it through
the fuselage.
5.
Thread the 2-56 end of the cable into the tub-
ing and pull the tubing out the rear cable exit.
.
Repeat steps 12 and 13 for the other end of
the cable.
Thread one 2-56 nut then a 2-56 golden clevis
onto the each end of the cable.
Connect the golden clevis to the black horn
bracket. Remember to insert the clevis clip on
each of the clips.
The other end of the cables will be finished when the
rudder servo is installed.
MOUNTING TAILWHEEL
Collect the following items:
(1) 6-32 x 3” All threaded rod
(2) Small White Adjustable Horn
(1) Tailwheel Bracket
(2) 4-40 x 1/2” Socket Head Bolt
(2) #4 Flat Washer
(2) Tailwheel Springs
