11
2
.
Install the cover door. Clear tape will hold it in
place and be easy to remove if needed.
3
.
* You will need a double sided heavy duty servo
output arm.
4
.
Measure 1/2” from the bottom of the rudder
and 3/8” back from the hinge line and drill a
9/64” hole for the rudder control horn. Install
the 6-32 x 2-1/2” threaded rod with a nut and
washer on each side. Center the rod in the
rudder. Install the nylon control horn fittings on
each end.
7
.
Install the pushrods in the servo output arm
and retain using the nylon swing in keepers.
5
.
Locate the two 2-56 x 9” pushrods and install
the nylon snap links on the ends as we did
with the ailerons. Install the silicone keepers
and attach to the pushrod fittings on the rud-
der.
6
.
Center the rudder servo and tape the rudder
in the neutral position. Mark the position of the
pushrods where they cross the control arm
and make a 90 degree bend. Cut the bend off
at 3/8”.
