17
8.
Reinstall the cowl and transfer the hole loca-
tion to the cowl.
The pipes can be cut just below the cowl and
the cowl will go on and off without removing
the muffler.
Throttle Servo Installation
2.
Glue the servo mount with cutout to the top of
the plate in the notch provided.
Glue the two 3/8” square rails to the bottom
side of the servo mount plate.
.
3.
Mount the servo in the tray using the hard-
ware supplied with the radio.
Glue the servo mount to the fuselage side on
the same side as the throttle arm on your
engine.
Glue in at a height that will match your throttle
arm.
4.
Locate the ez-connector and remove the nut.
5.
Attach the ez-connector to your servo arm.
Put a drop of CA on the nut to make sure it
does not come loose.
1.
Collect the following items:
(1) 2-56 x 18” throttle pushrod
(1) 5/32” nylon tube
(1) nylon snap link
(1) e-z pushrod connector.
(1) laser cut servo mount
(2) 3/8” x 3/4” spruce blocks
