8
4.
Install the blind nut in the wheel pant using the
4-40 bolt to pull it into the hole.
Wheel Collars
Wheel Pant
Wheel
Landing Gear
5.
Mount the wheel pant on the landing gear
along with the wheel collars and wheels.
Center the wheel on the axle.
Use the 4-40 x 1/2” bolt to hold the wheel pant
to the gear. Be sure to use lock-lock on the
bolts.
HINGING RUDDER
1.
Locate the rudder and four hinges
Trial fit the hinges to make sure they all go up
to the hinge pin in rudder and fin.
2.
Trial fit the rudder in place on the fin. Make
sure the hinge line is tight and the counter bal-
ance does not rub on the top of the fin.
Insert a piece of wire into the outlet hole for
the rudder cable (holes are just below the ele-
vator servo cutout) and make a mark on the
rudder in line with the outlet hole.
3.
Transfer the mark to the other side of the rud-
der
Drill a 9/64” hole at the location marked. Drill
half way from each side until the hole is com-
pletely through.
