Carinci evolution, User Manual

Page: 27 / 44

27
7.2 FUEL DIMENSIONS
The size of the wood affects the efficiency of the thermo fireplace, so
the advice is to use a fuel variety which reflects the following features:
a) The wood positioned at the bottom must have a length between
30 and 45 cm and a perimeter between 20 and 50 cm;
b) The wood positioned in the middle should have a length between 30
and 45 cm and a perimeter between 10 and 20 cm;
c) The bundles must be positioned above the two layers previously
placed and may be formed from a very small piece of wood, small
wooden boards, etc.
The size of the pellets must not be more than 6 mm in diameter.
8.0 ADJUSTMENTS
8.1 CIRCULATOR ADJUSTMENT AND SYSTEM BALANCING
a) The circulator must be proportionate to the size of the system;
b) It is recommended to always make it work at minimum speed and to adjust the inflow of water in the radiators closer
to the collector (through the adjustment screw of the flux valve), in order to avoid the annoyance of dripping and
improve the inflow of water in radiators furthest, thus improving their efficiency;
c) In case the minimum speed is not enough, switch to the average speed, check the radiators performance, and if it is
not sufficient yet, switch to the maximum speed.
1 2 3
8.2 COMBUSTION ADJUSTMENT
Every thermo fireplace CARINCI is equipped with a very simple system for adjusting the combustion which is located in
the upper right side of the door, that, by using a 5 mm hexagonal key (called Allen key), allows the user to adjust the
width of the air throttler rings, in order to have a homogeneous flame throughout the combustion chamber.
The proper combustion is obtained when the flame is neither too powerful nor too weak.
If a proper burning does not take place using the thermo fireplace, it is possible to adjust the air flow in the following way:
a) Insert the hexagonal key (Allen key) into the combustion regulator located on the top right of the door (see figure);