LB-05053-03-GB
Pag. 11
03-04-13
DOSE PROGRAMMING
The following procedure is the same for both 1 and 2 group versions. Please note that the display messages are shown just in the 2
group version, which is equipped with display.
1) Programming the volumetric coffee dose.
The following procedure is valid for all coffee keys.
•
Press key N°5 ( contin./ progr.) of the first keypad and keep it pressed for ten seconds. The programming level is shown by
the flashing LED for all keys.
•
press the coffee or
hot water dose keys
to be programmed and the beverage will start being dispensed;
The display shows:
KEY 1 KEY 2 KEY 3 KEY 4
KEY 5
•
press the selected dose key again when the required dose has been delivered. The dose will be stored in memory
automatically.
The planning effected on the left group will be brought on all the machine keypads.
In the case is required to diversify the doses from the remainders keypad, repeat the procedure on the right keypad.
Please Note:
•
The pre infusion is enabled only for Tx1 e Tx2 of each group
•
To go out of the programming phase without modifying the parameters, is necessary to attend the time - out of thirty
seconds without pressing any key.
DEFAULT DELIVERY SETTING
Drink name key
Tea 1
Tea 2
1
ESPRESSO
2
ESPRESSO
1
COFFEE
2
COFFEE
CONTINUOS
KEY
Water volume
Tea 1 =10sec
Tea 2 =20 sec
40 cc
40 cc
80 cc
130 cc
500 cc
Preinfusion cc
3 cc
3 cc
0 cc
0 cc
N.A
Preinfusion sec
2 sec
2 sec
OFF
OFF
N.A