Carguard G 7050, User Manual

Page: 13 / 88

13
G 2500 English
23. Activate arm mode under emergency:
1) Open car door,turn on ignition.
2) Press
”Override” button 3 times.
3) Turn off ignition
（
Siren chirps 1 time,parking light flashes 1 time
）
4) Sytem will activate arm mode after 20 seconds if car door is not closed.
Attention! If you use arm mode under emergency feature,system will delay to turn on siren by 20
seconds when this feature has been activated ,therefore you are able to deactivate arm mode without turn
off sirens.
2. Deactivate arm mode under emergency
1) Open car door,turn on ignition.
2) Please press
”Override ” button 3 times.
3) Turn off ignition
（
Siren chirps twice,parking light flashes twice
）
4) Arm mode will be deactivated immediately.
Attention! If you had set up PIN code,you will need to enter PIN code to decativate arm mode under
emergency.
24. Personal password
（
PIN code
）
The password
（
if it has been set up
）
can be used to deactivate arm mode even without the remote or
to disable anti-carjacking mode in steps 2 and 3.
PIN code is a 2 digits combination.
Attention! The default setting of PIN code is 1
：
1
First digit Second digit
1
（
x
）
1(y)
Please use PIN code to deactivate arm mode.
If your remote is out of order,or the system is under step 2 or 3 of anti- carjacking mode,then you can
use PIN code to deactivate arm mode.
You will have to
：
1. Open car door,turn on ignition
2. Press
”Override” button for X times(First digit of PIN code)
3. Turn off ignition
4. Turn on ignition again
5. Press
”Override” button Y times(Second digit of PIN code)
6. Please turn off ignition.If you enter correct PIN codr,arm mode will be deactivated.
Attention! You may need to repeat these steps if wrong PIN code is entered .
25. Reset PIN code
Attention! You can reset the PIN code only when
“Enter PIN code to close system under emergency”
feature has been programmed.
（
Please refer to Multi-level security arming mode setup chart
）
In order to reset PIN code,you will need to
：
1. Turn off ignition.
2.
Press “Override” button 4 times.
3. Turn on ignition,Siren will chirp 4 times.
4.
Press”Override” button 1 time to enter Reset PIN code feature..
5. Use the remote to enter PIN code's first digit.