3
Vedpak 132_501186_Version 4_12.2017
211097
HOOK-UP
Unroll the cable.
Connect the RED battery hook-up clip to the POSITIVE
(+) terminal of the vehicle’s battery.
Connect the BLACK battery hook-up clip to the
NEGATIVE (÷) terminal of the vehicle’s battery.
When the tester is first connected to a battery (power
source), it will sound a quick high and then low beep and
go into “Power Probe Mode“ (See Mode #1 on page 9)
and the 2 bright white LEDs 8dual head lights9 will be on
to illuminate the test area of the probe tip.
QUICK SELF-TEST
While the tester is in Power Probe Mode, press the po-
wer switch forward to activate the tip with a positive (+)
voltage. The positive sign (+) LED should light red and
the LCD display will read the battery (supply) voltage.
If the tone feature is turned on, a high pitched tone will
sound.
Press the power switch rearward to activate the tip with
a negative (÷) voltage. The negative sign (÷) LED should
light green and the LCD display will read “0.0“ (ground).
If the tone feature is turned on, a low pitched tone will
sound. The tester is now ready to use. If the indicator did
not light, depress the reset button of the circuit breaker
on the right side of the housing and try the selftest again.
TURNING THE AUDIO TONE ON AND OFF
While the tester is in Power Probe Mode, just do a quick
press of the mode button to toggle the tone on or off.
While quickly pressing (a quick press and release) the
mode button, if a short high beep is heard, this means
the audio tone is turned on. If a short low beep is heard,
the audio tone is off.
