Carf-Models CL-41 Tutor, Manual

Page: 11 / 44

Composite ARF Tutor T-114 manual – techsupport@composite-arf.com
9
The flap linkage is assembled using two M3 x
140mm all-thread rods fitted with a locking nut
and steel M3 clevis at each end.
To allow perfect flap operation it is important
to set the two flap servo arms neutral with your
radio in the centre position of any control switch
or lever (take off Flap), the arm should then be
moved one spline forward of this position to aid
full flap movement. From this point the arm will
swing forward and back. Some additional ATV
may be required to gain the optimal landing
flap angle.
The flaps are hinged using three M3 x 12 Allen
screws and nylon stop nuts screwed through the
three factory fitted hinge arms. (Photo 5)