T
RAVEL
'
R
Service Manual
Carefree of Colorado
22
052540-301r10
P
ROGRAMMING THE
R
EMOTE
R
ECEIVER
Remotes are available with the factory installed Direct Response system. Remotes are not available for
the Direct Response LCDR upgrade system.
When adding or replacing a remote control, it is necessary to program the transmitter and receiver.
1. Power to the control box must be on.
2. Press and release the “Press to Learn Transmitter” button
on the bottom of the receiver box. The receiver is in
program mode when the red light comes on.
3. Press and release the
STOP
button on the remote. The
red light will go out after the receiver learns the remote
signal.
NOTE:
Pressing the stop button will cause the blue up
arrow button to default as the close (retract) function.
If a function button is pressed to train the receiver, it
will be programmed as the retract button. Example:
Pressing the top button will program the top button for
retract and the bottom button as extend.
Operational Notes:
Transmitter and receiver operate on frequency 433 MHz.
The receiver exits the program mode after ten seconds.
If the light does not come on, the memory is full and must be cleared.
To clear the memory:
PRESS AND HOLD
the transmitter learn button. While holding the button, the indicator light
should be OFF for the full 5 seconds then come on.
If the light does not go out during programming, the receiver already knows the transmitter's signal or the
battery in the remote needs to be replaced.
The system may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
DR020
T
O
EYE PO
R
T
on RP24
Program
Mode
Press to Learn
T
ransmitte
r
UP
Program
Button
Indicator
Light
Stop
RR