M
ARQUEE
Service
Manual
Carefree of Colorado
8
052549-301r7
S
ETTING THE
M
OTOR
L
IMITS
The limit switches are located inside the case,
near the end cap. It is necessary to extend the
awning to access the switches. The “
OUT
” limit
switch stops the motor when the awning is fully
extended. The “
IN
” limit switch stops the motor
when the awning is fully retracted.
The limit switches are located inside the case. It
is necessary to open the awning to access the
switches.
Out Limit Switch
1. Extend the awning out completely.
2. Confirm that the arms are fully extended. The motor should stop and the fabric should be tight. If the
motor continues to run, the fabric will sag; or, if the motor quits before the arms are fully extended, it will
be necessary to adjust the “
OUT
” limit switch.
NOTE:
It is best to make the adjustments in increments of a single turn. 3 full turns of the screw
equals approximately 2” of fabric extension.
3. If the fabric sags:
3.1. Retract the awning until the fabric is tight then retract an addition 10"-12".
3.2. Using a 4mm Allen wrench turn the “
OUT
” limit switch
COUNTERCLOCKWISE
to reduce the time the
motor runs.
3.3. Extend to confirm that the adjustment is correct.
3.4. Repeat the procedure until the awning extends correctly.
4. If the arms do not extend completely:
4.1. Retract the awning approximately 10"-12".
4.2. Using a 4mm Allen wrench turn the “
OUT
” limit switch
CLOCKWISE
to increase the time the motor runs.
4.3. Extend to confirm that the adjustment is correct.
4.4. Repeat the procedure until the awning extends correctly.
IN Limit Switch
1. Retract the awning in completely.
2. Confirm that the arms are fully retracted. The motor should stop when the awning is fully retracted. If
the motor quits before the arms are fully retracted; or, if the motor continues to run after the awning is
closed, it will be necessary to adjust the “
IN
” limit switch.
NOTE:
It is best to make the adjustments in increments of a single turn. 3 full turns of the screw
equals approximately 2” of fabric extension.
3. If the motor stops before the awning is fully retracted:
3.1. Extend the awning 10"-12".
3.2. Turn the “
IN
” limit switch
CLOCKWISE
to increase the time the motor runs.
3.3. Retract the awning to confirm that the adjustment is correct.
3.4. Repeat the procedure until the awning retracts correctly.
4. If the motor continues to run:
4.1. Extend the awning approximately 10"-12".
4.2. Turn the “
IN
” limit switch
COUNTERCLOCKWISE
to decrease the time the motor runs.
4.3. Extend and retract to confirm that the adjustment is correct.
4.4. Repeat the procedure until the awning extends correctly.
Marquee008
“OUT”
“IN”
4mm Hex
4mm Hex
