UI SmartSeat seat height supplemental iss02, 07/2014
If the covers of the side panels pull away
from under the arm mounting trim plates,
loosen the screws holding the trim plates in
position and tuck the edge of the cover back
under the trim plate.
Re-tighten the trim plate screws to hold the
cover neatly in position.
Once the main adjustment has been made
at the sides of the chair the TiS control
needs to be re-fitted at the appropriate
height setting.
There are three height settings into which
the interfacing bracket can be fitted
consisting of two holes. The bottom two
holes correspond with the lowest height
setting, the middle two holes the mid-point
setting and the top two holes the highest
setting.
It is essential that the interface bracket is
fitted between the correct holes. Never
attempt to re-position the interface bracket
in an attempt to increase or decrease the
range of Tilt-in-Space.
Position the interface bracket in the main
bracket on the frame crossbar and line up
the appropriate set of holes.
Re-fit the bolts removed earlier through the
assembly and fasten them in place with the
nyloc nuts. Use a 5mm allen key and 13mm
spanner to ensure the assembly is fully
tightened.
If necessary, loosen off the arm mounting
point trim panels to ensure the cover is trapped
securely in position.
Re-fit the TiS interface bracket into the
appropriate holes on the bracket on the castor
frame crossbar.
low set
mid set
top set
