Smart
Seat
®
UI SmartSeat seat height supplemental iss02, 07/2014
TM
When adjusting a manual chair, undo the
screws which hold the legrest release
lever in place on the right side of the chair.
Use a cross-head screwdriver to undo the
screws and carefully pull the lever out of its
aperture. Do not disconnect the cable.
The front inner top edge of the side panels
have a small cover panel which clips over a
wire on each side of the seat board. Un-clip
the J-strip from this wire to reveal the nuts
which hold the side panels in place.
Undo each of these nuts using a socket
wrench with a 13mm socket. There are five
nuts each side and the two rear nuts can
be obscured by the sides of the back frame
depending on the seat depth adjustment of
the chair.
Adjust the seat depth so that all five nuts
from each side can be accessed and
removed. Keep the nuts in a safe place for
future re-fitting.
The side panels are now only held in place
by the arm fitment trim plates and care
needs to be taken not to attempt to move
the chair by pulling the side panels. Handle
the side panels very gently to avoid damage
to the covers.
Carefully angle the side panel out to give
access to the height adjustment points on
the frame.
Locate the 4 nuts in front of the chair back.
Undo the top and bottom screws holding the
legrest release lever.
