UI SmartSeat seat height supplemental iss02, 07/2014
3
Adjusting seat height takes approximately
15 minutes. The chair can be adjusted
one side at a time but both sides must be
adjusted to the same height before the
chair is used.
Begin the process by tilting the chair
forward into its upright position. Do not
adjust tilt again as this will cause the gas
action or motor to over extend, which will
make re-fitting exceptionally difficult.
Locate the Tilt-in-Space (TiS) interface
bracket on the back cross bar of the castor
frame. The bracket is held in place with two
bolts.
Use a 5mm allen key and a 13mm spanner
to undo the two bolts holding the interface
bracket in place and carefully lower the Tilt
action to rest on the floor. Put the bolts and
nuts in a safe place ready for re-fitting at
the end of the height adjustment process.
Remove both of the chair arms as per the
main SmartSeat user instructions.
Undo the zip holding the two halves of
the crumb catcher between the seat and
legrest.
Remove the seat cushion by un-clipping
the J-strip on the underside front edge of
the seat cushion and on the flap at the back
of the seat cushion.
Disconnect the TiS interface bracket first.
Undo the crumb catcher zip and remove the seat
cushion.
Unclip the J-strip on the small cover panel to the
front top edge.
