20
5 . BAT T ERY CHA RGING A N D CA R E
■
Battery replacement
Follow the procedure below step by step to replace the batteries:
1.
Remove the battery pack from the Easi Go.
2.
Open the battery pack then disconnect the cables from the four battery terminals.
3.
Remove the batteries from the battery pack.
4.
Place new batteries inside the pack.
5.
Connect the red cable to the po) battery terminal and black cable to the negative(-)
on the
other battery.
6.
Connect up the fused cable between the two batteries and close the battery pack.
Warning
：
1. The wiring system and charger are placed correctly in the battery pack during assembly
by the manufacturer. Do not attempt to re-locate the wiring system by yourself. The
improper layout of wiring system may result in the wires being pinched by the battery
box, which could result in an electronic system failure.
2. Be sure the battery wires are connected to their correct battery terminal.
Suggestions
：
1.
Make sure the terminals are installed properly and replace the cover.
2.
Battery efficiency will vary with outside conditions; driving range will be reduced in
cold
weather. If the power chair is not used for a while, charge the batteries at least once
a week.
3.
Replace both batteries together.
