![background image](http://html1.mh-extra.com/html/cardin/morph433w00/morph433w00_manual_2555986016.webp)
16
The interface site must be:
- indoors (or stored in a waterproof container if installed outdoors)
- a position safe from accidental collision;
- in a position which the technician can easily reach.
Fastening
:
• Remove the two holding screws and lift up the cover
• Using the container as a template mark the four points at which the fastening holes are to be drilled and
fasten down using four self-tapping
M4
screws and relative rawlplugs (not supplied with the kit).
• Remove the two plastic cable dividers.
Connecting the external aerial ANS400
Attention!
An aerial must be installed on the stationary transceiver.
To obtain the best results from the transceiver the aerial installation site should be carefully chosen. ‘Range’
is intended to mean the working distance, measured in free space, between the stationary interface and the
mobile transceiver with the aerial installed. The range is therefore closely linked to the technical characteristics
of the system and varies according to the characteristics of the site in which the system is located. For best
performance we advise you to use the Cardin
ANS400
aerial. Wire the aerial to the stationary transceiver unit
using a coaxial cable
RG58
(impedance
50Ω
) with a maximum length of
15 m
.
• It is possible to connect two aerials in order to improve the signal and consequently the range.
Electrical connection
Warning!
The receivers must only be powered by a safety power pack. The use of non safety
power packs could provoke damage to the system.
The interface (printed circuit CS1405B) is fitted
with an indoor container and has a 15-way terminal
board with the following electrical connection:
12V ac/dc
between binding posts
5-6
24V ac/dc
between binding posts
5-7
INSTALLING THE MORPH433W00 MULTIPROTOCOL INTERFACE
CS1405B DC0511
1
2
RF MODULE 433 MHz
1
S1
2 3
ON
4
J1
J6
J6
1 2 3
Pos.1
1 2 3
Pos.2
J1
Pos.2
Pos.1
USB
CON1
1 2 3
Pos.3
3
4
LGC
MEMO
DEL
CODES
27-09-2003
DC0365
Description :
Product Code :
Date :
Drawing number :
P.J.Heath
CARDIN ELETTRONICA S.p.A
- 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
Draft :
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
5 6 7 8 9 10 11 12
12V
0
24V
13 14
D
AT
A0 / RCP
CLS / AUX
GND
EN
D
AT
A1 / RDP
RCQ449W00
WIEGAND
15
DLS
IN-STS
GND
Summary of Contents for MORPH433W00
Page 50: ...50 NOTES ...
Page 51: ...51 NOTES ...