24
DISPLAY MODE
Using the
PROG
button you can access the following functions in sequence:
- memorising the status of the dip-switches;
- display the status of the command and safety devices;
- display the number of manoeuvres;
ACCESSTHE
test
MODE
- enabling/disabling automatic reclosing in the presence of an obstacle;
- setting the current sensor level;
- setting the distance from the opening direction travel limit (indicative values).
10 sec
7HENTHE
TD-TB-FTCI
INPUTSAR
e activated
the warning and courtesy lights will light up.
The status of the security devices
TB
and
FTCI
are always shown on the display.
PREMERE
PROG
10 sec
5 sec
10 sec
SNS
Setting the current sensor.
MOTORCONSUMPTIONAMP
MOTORCONSUMPTIONAMPS
MOTORCONSUMPTIONAMPS
PRESS PROG
%ACHTIME02/'IS
pressed the number will
increase (from 1 to 3).
10 s after the last modification you
will be automatically moved out of
the mode and the selected values
will be saved (eg. 3)
10 seconds after the last
modification the program
will save the chosen value
(e.g. “0” and exit
automatically
10 sec
10 sec
10 sec
PRESS
PROG
The segments regarding the command status (LED
“ON”
command active) and safety status (LED
h/.vSAFETYDEVICEAT
rest) light up.
The number of manoeuvres appears on the display.
This number always remains visible until you change
the setting. Once
999999
has been exceeded the
lighting up of the decimal point on the display
equals 1 m the six figure number.
In the
TEST
mode (only activated when the motor
has stopped) it is possible to check the status of the
command and safety devices. The warning lights
will activate once, each time a “
TD-TB-FTCI
”
command is received. In this mode you can activate
serial line communication by using the external
program, which is to be connected to the
CSER
connection via cable (fig. 13). While communication
is active dashes will appear on the display; after 5
seconds of inactivity you will be moved back to the
TESTMODE
To return to the normal operating mode
press the button again “test” will appear, then wait
for 10 seconds.
Memorising the DIP-SWITCH settings and
displaying the firmware version (e.g. “
14
”)
drA
Setting the reclosing function
with an obstacle:
hvTHEPR
ogrammer tries to close three times.
hvTHEPR
ogrammer tries to close once
10 sec
Each time the
PROG
button is
pressed the selection
alternates between
“1” and “0”.
PRESS PROG
PRESS PROG
PRESS PROG
PRESS PROG
Connect the
programming device
(
CSER
) and activate it.
PRESS PROG
PRESS
PROG
10 sec
10 sec
PRESS
PROG
dSt
3ETTINGTHEDISTANCEFR
om the opening
direction travel limit (approximate values)
- “
0
v
0
centimeters - “
1
v
1
centimeter
- “
2
v
2
centimeters - “
3
v
3
centimeters
PRESS PROG
Each time
PROG
IS
pressed the number will
increase (from 0 to 3).
10 s after the last modification you
will be automatically moved out of
the mode and the selected values
will be saved (eg. 1)
