Carbine PLUS-4500, User & Installation Manual

Page: 8 / 20

8
Starter
87
87a
86
85
30
87
87a
86
85
30
"ACC" "START"
CUT
"OFF"
"ON"
"ACC"
"START"
"OFF" "ON"
CUT
Black Wire
Black Wire Black Wire
White Wire
White Wire
Power Supply
to Fuel Pump
Power Supply to
Ignition Coil or ECM
Power Supply to
Fuel Injectors
Red Wire
Orange
2-Pin
ALA-RPS2
Starter Disable and Engine Disable Using Optional ALA-RPS2 Relay Pack
Using the wiring information and diagram below, connect the optional starter disable relay as follows:
A. Locate the “Start Only” wire coming from the ignition key switch and cut it.
B. Connect the ends of the cut start wire the black wires coming from the ALA-RPS2 relay pack.
C. Locate the power supply wire to any of the fuel management circuits listed below and cut it.
D. Connect the ends of the cut wire the white wires coming from the ALA-RPS2 relay pack.
E. Plug in the orange 2-pin plug into the orange socket located at the rear of alarm module.
To test the dual circuit disable system, refer to the starter disable testing procedures located in the
testing section of this manual. (Page 16)
Step 5: Optional Accessory Connections
(Continued)
Starter Disable Wiring Using Optional ALA-RPS Relay Pack
Using the wiring information and diagram below, connect the optional starter disable relay as follows:
A. Locate the “Start Only Wire” coming from the ignition key switch and cut it.
B. Connect the ends of the cut start wire the black wires coming from the ALA-RPS relay pack.
C. Plug in the orange 2-pin plug into the orange socket located at the rear of alarm module.
To test the starter disable system refer to the starter disable testing procedures located in the testing
section of this manual. (Page 16)
87
87a
86
85
30
Black Wire
"ACC" "START"
"OFF"
"ON"
Cut
Starter
ALA-RPS
Relay Pack
Red Wire
(Ign. Sw12VDC)
(Ground when Armed Alarm Output)