docs.carbide3d.com
12/2/19 v1.0
6
Version 2.1/2.2/2.3 (Using the Legacy Adapter Cable)
1.
Connect the female connector (green and white wires) to the probe pins as shown in
Figure 9
.
2.
Connect the red wire (+5V) to the upper-left
pin on the
AVR PROGRAMMING
label as
shown in
Figure 10
.
3.
Once both wires are plugged in, your board
should look like
Figure 11
.
4.
Connect the Legacy Adapter Cable to the port
labeled
TO CARBIDE MOTION
on the Probe
Adapter PCB.
5.
Connect the BitSetter to the port labeled
TOOL PROBE
on the Probe Adapter PCB.
NOTE:
If you also have a Carbide 3D probe, plug that into the port labeled
TOUCH PROBE
on the Probe Adapter
PCB.
Figure 9
Figure 10
Figure 11
