docs.carbide3d.com
8/26/2020
Version 1.0
14
Install the Tramming Plate to the Z-Plus
1.
Install the tramming plate to the front of the
Z-Plus. See
Fig. 13
.
a.
Align the tramming plate with the four
available M5 holes.
b.
Use a 4mm hex key and four (4) M5
×
8mm
SHCS to secure.
2.
Install the router mount adapter ring if you have a
65mm router.
Install the Z-Axis Proximity Switch to the Z-Plus
1.
Install the Z-Axis proximity switch to the front of
the Z-Plus. See
Fig. 14
.
a.
Check to make sure the leadscrew stopper, the silver cylinder at the bottom of the leadscrew, is
present and tighten if necessary.
b.
With both hands grasp the sides of the
Z-Plus and, slowly but firmly, lower the
Z-carriage with your thumbs until it stops
at the bottom.
c.
Insert the Z-Axis proximity switch cable
through the hole at the top of the Z-Plus,
just under the Z-motor.
d.
Position the proximity switch with the red
LED facing front and the target pointing down.
e.
Align the proximity switch
’s
mounting slots with the two M3 holes at the top of the Z-Plus.
f.
Use a 2.5mm hex key and two (2) M3
×
18mm SHCS to secure the proximity switch.
i.
Before fully tightening the screws, slide the switch up as far as it will go.
Figure 13
NOTE:
If the leadscrew stopper is missing from
your Z-Plus, please stop the assembly process here
and contact us at
. If you
continue with the assembly process, you could
damage your Z-Plus.
Figure 14
