Version 11.02.2015
C4-LR12-NC
Pa
ge
16
4.4.
Assigning device controls for connected AV-sources (AV2/3)
After selecting the c.LOGiC as current AV-source (see chapter “Selecting the c.LOGiC as
current AV-source”) choose the relevant AV-source (AV2 or AV3) by short pressing the
AUDIO/VIDEO button. After it:
•
Press AUDIO/VIDEO button for 3 sec.(back into the factory mode)
•
Press AUDIO/VIDEO button for 10 sec. (interface switches to the last AV-source and
starts the programming mode), the blue LED is blinking fast
•
within 40 seconds
, enter the device-related IR-code for AV2 (AV3) as described in
device control table (appendix A) by touch-screen, see picture of apportionment of
the numbers below
•
the blue LED is blinking as often as the corresponding number of the RC-code
(e.g. the blue LED is blinking 10 times for RC-code “10”).
Do not press any button or the touch-screen while the blue LED is blinking because the
programming will not be stored and must be restarted!!!
Note:
The IR-control channels for AV2 and AV3 are preset to RC-Code 41 compatible
DVB-T tuners.
