-
Make sure that the section of the conductors in
the power supply cable is sized in accordance
with the starting current and length of cable.
For cables of up to 50 m long, a section of
4 mm
2
is sufficient.
-
Before connecting the machine to the power
socket make sure that the power supply voltage
is the same as that indicated on the machine's
plate.
-
Only connect this machine to power supplies
that are efficiently earthed. In case of doubt do
not connect this machine up.
THE S-COUP 350 IS DESIGNED TO WORK WITH
WATER.
-
Before starting to cut make sure that the water
level in the tank is as shown in the photo.
-
Make sure that the power supply cable cannot
get caught up in the cutting operations.
Use the cable clamp lever to keep it in place.
Check that the power is on before using the
machine.
BEFORE STARTING TO CUT MAKE SURE THAT
THE MATERIAL TO BE CUT IS PROPERLY
SUPPORTED AGAINST THE CLAMP ON THE
WORKING SURFACE.
Using the locking lever, secure the motor head as
shown in photo 12.
-
Set up the piece to be cut on the working
surface at the required dimension.
-
Start the machine and wait until the cooling
water flows out over the cutting disc. Then
adjust the flow of water using the water
stopcock on the disc guard.
-
Proceed to cutting, moving the working surface
forward as shown in photo 13.
For making diagonal cuts, rest the piece on the
square (photo 14) and proceed to cut.
For making 45° cuts, use the jolly cutting accessory
(optional) (photo 15).
GB
28
1
13
3
1
12
2
8. Making a square cut
CAUTION !
1
11
1
7. Checks before use
CAUTION !
1
10
0
