Carat FASN8016-2, Operating Manual

Page: 28 / 44

28
ACTUATING TOOL
Warning: Always wear eye and hearing protection when operating tool.
„
For SN8016 - SN8016LN :
See graphic A pag. 3
• Point the nose to surface of the material which the fastener is being driven into. Be sure the tool is
straight and then depress the trigger to drive the fastener.
• The stapler will only fire once if the trigger is held up. The trigger must be released to fire a second
staple.
„
For SN8025 only :
See graphic B pag. 3
Switchable Trigger
The tool can be actuated using either of “Sequential Fire” or “Bump Fire”.
„
Push the button forward at both side of trigger to set up for bump fire.
„
Push the button backward at both side of trigger to set up for sequential fire.
"Bump Fire"
• With your finger pulling the trigger, press the safety all the way down on the surface of the material
the nail is being driven into.
• This will result in a nail being driven into the material.
• To fire another round raise the safety completely off the material and repeat the above steps.
"Sequential Fire"
• With your finger off the trigger, then hold the safety nose FULLY against the work surface of the
material the nail is being driven into.
• Pull the trigger firing a nail into the material.
• The tool will not fire again until the trigger is release and the safety is removed completely from the
material being used.
• To fire the next nail repeats the above steps.