Carat C 2067, Operating Instructions Manual

Page: 30 / 72

Standard for Art. 65671, 65901.
One person, using the "MOVING WHEELS"
accessory, can move the machine.
IN ORDER NOT TO COMPROMISE THE STABILITY
OF THE MACHINE, FOLLOW THE INSTRUCTIONS
BELOW CAREFULLY.
SUPPORT THE MACHINE WHILE INSTALLING THE
WHEEL KIT.
With the machine in a working position:
a) loosen the leg-lock on the opposite side to that
of the control unit;
b) lift the leg and insert it into the wheel support
(photo 8);
c) lock the leg in position using the leg lock;
d) tighten the wheel support screws (photo 8);
e) repeat this operation on the other leg.
TO FACILITATE MOVING THE PRIME ON SITE, IT
IS ADVISABLE TO PUT IT IN THE LOWERED
POSITION.
a) Slacken the leg locks on the front one at a time,
supporting the machine by the carrying handles;
b) lower the front of the machine by allowing the
legs to slide into the supports until the middle
hole on each leg is aligned with the hole in the
supports (photo 9);
c) lock the legs in position using the relevant
clamps;
d) repeat the operations indicated under a), b),
and c) for the rear side.
MOVE THE MACHINE AS SHOWN IN PHOTO 10.
This machine must be connected to the power
supply, protected by a trip switch or a c 2067/90 II
insulating transformer, with the following
characteristics:
Differential In 6 A Id 30 mA
Transformer 230 V 50 Hz 1500 W
Continuous Use
N.B. To use the trip switches correctly, do not
forget to check that they are working properly
from time to time, by pushing the relevant
button on the front of the unit itself.
Before connecting the machine to the power socket
make sure that the power supply voltage is the
same as that indicated on the machine’s plate.
GB
30
4. Moving wheels Kit
5. Connection to the power supply
8 8
WARNING !
INFORMATION
1 10 0
9 9