3. Settings
3.3.1 FACTORY MODE-IMAGE, PARK
IMAGE
Adjust navigation position and size
H-POSITION : Move display horizontally
V-POSITION : Move display vertically
FACTORY mode – Press
◀
button 2 seconds long on the remote control.
PARK
PAS TYPE : Selecting Type of parking guide line
- NOT USED : Not use Parking guide line
- PAS ON : Selecting Dynamic Parking guide line
- PAS OFF : Selecting fixed Parking guide line
PAS SETUP : Adjusting the position and Selecting
type of the parking guide line
REAR TYPE : Choose rear camera recognition
* LAMP - Detecting the rear view camera via
rear lamp (Installer must connect “Rear-C”
cable of the power cable to the rear lamp
of the car.)
*CAN - Detecting the rear view camera by
CAN signal (Installer must connect “CAN”
cable of the power cable to the “CAN”
cable of the car.)
SAFE ENABLE : If your car is connected with CAN
cable and it is in ”ON” state, you
can NOT watch DVD or A/V
except original image or
navigation while driving. At that
time the screen get back to the
main (default : OFF)
RADAR ENABLE : When set the gear to “R”, Display
PDC
14
www.car-solutions.com
www.car-solutions.com
