Version 17.02.2020
HW: LVDS(50)
CI-VL2-LR14-OPS
P
a
g
e
7
1.3.4.
Dip-Schalter Einstellungen – CAN box (4dip – red)
Choose the navigation, the interface shell be connected to
and set dip 1 to 4 according to the below table.
Fahrzeug/Infotainment
Dip 1
Dip 2 Dip 3 Dip 4
All Range Rover vehicles
ON
ON
ON
ON
Discovery 4
OFF
OFF
ON
OFF
Discovery Sport
ON
ON
OFF
OFF
Freelander 2
OFF
OFF
OFF
ON
Jaguar
ON
ON
ON
ON
Note: The experience values of the CAN bus dip settings are only exemplary. If the Can
communication doesn’t succeed, try other dip combinations.
After each Dip-switch-change a power-reset of the Video Interface has to be performed!
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation – video interface and CAN-bus box
The interface box and the CAN-bus box are prepared to be connected and installed behind
the vehicle`s head unit.
The daughter PCB is prepared to be connected and installed inside the head unit.
