Version 12.05.2021
HW:CAM (V100)/(V42,V43,V44)
CI-RL4-C3D
P
a
g
e
6
1.4.1.
Activating the front camera input (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
Description of the front camera power supply: see chapter “Power supply output”.
1.4.2.
Enabling the interface’s video inputs (dip 2-3)
Only by dip switches enabled video inputs can be accessed by switching through the
interface’s video sources. It is recommended to enable only the required inputs. Disabled
inputs will be skipped while switching through the video interfaces inputs.
1.4.3.
Activation of the factory PDC display (Dip 4)
Dip 4 is used to display the factory PDC (if available) as „picture in picture“ in combination
with the camera image.
1.4.4.
Rear-view camera setting (dip5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.5.
Activating the guide lines (dip6)
If set to ON, the guide-lines will be shown on the display.
If set to OFF, the guide lines won’t be visible on the display.
Note:
If there is no communication between interface and the vehicle`s CAN-bus (several
vehicles aren’t compatible), the reverse gear guide-lines can`t be shown during the vehicle’s
operation, even if they once appear after having switched the system to powerless!
1.4.6.
Monitor selection (dip7 and 8)
Dips 7-8 customize the monitor-specific video settings which cannot be predicted as even
within the same head-unit version, the monitor specifications may vary. It is necessary to try
all possible combinations - while a working video source is connected to the chosen input of
the interface - to see which combination gives the best picture quality and size (some may
give no picture). It is possible to first hot plug through the dip combinations, but if you do
not experience any change of picture after trying all options, retry and disconnected the 6pin
power plug of the video-box between every change of the dip setting.
