Version 17.02.2020
HW GD(V97)
CI-UCON5N
P
a
g
e
11
2.3.1.
Exception for Jeep - Chrysler vehicles
In Chrysler vehicles, the ribbon cable
connection takes place at the daughter PCB’s
upper ribbon cable base
„CHRYSLER USES“
(see illustration beside). For that, the daughter
PCB first has to be removed from the Exchange
housig base plate. The daughter PCB is pre-built to
be fixed inside the head unit housing by using the 3
screws, after the ribbon cable connection is done (heed
the following warning notes!).
2.3.2. Warning notes, concerning the installation of ribbon cables:
1) The contacting ends of ribbon cables always have to be installed in a straight and
precise 180° position to the connector. Each deviation from a perfect contact position will
curse faulty contact and even danger of short circuit
2) The ribbon cable’s contacting side always has to correspond to the contacting side of
the connector, concerning the mounting position.
3) Avoid cable contusion or cable injury caused by sharp-edged metal.
