Version 30.12.2021
HW: CAM(V100)/(V11+V41)
ab Serien Nr: NZ20NOV694
CI-RL4-SY3-R5
P
a
g
e
8
1.4.2.
4 dip - red
By using the Dip-switches, the vehicle can be chosen which the interface
will be connected to.
Dip position down is ON and position up is OFF.
Vehicle/Navigation
Dip 1
Dip 2
Dip 3
Dip 4
Ford
ON
OFF
Sync 3 light (R5) ON
Sync 3 full version OFF
OFF
z.B. Ford Focus 2019
ON
ON
Sync 3 light (R5) ON
Sync 3 full version OFF
OFF
After each Dip-switch-change a power-reset of the Video Interface has to be performed!
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation
The picture signal cable is connected behind the monitor. The PNP power / CAN cable is
connected to the factory radio module (head unit), a DIN housing. In most vehicles, this is
located behind/below the monitor in the centre console. There is no APIM module with
these Sync versions.
