Version 08.12.2015
CI-C1-RNSE
Pa
ge
7
3.3.2.
Installing AV-source’s IR-sensor additionally
Additionally to the control via OEM navigation, it is possible to install the original IR-sensor
of a connected device. By using the respective Y-adapter (e.g. STA-Y35MM or STA-RJ12) for
the IR-Port of the connected device, the controls of navigation AND device’s IR-sensor can be
connected and used simultaneously. Installation of the IR-sensor is recommended as the
controls via navigation are limited, and not all functions may be covered.
3.3.3.
After-market rear-view camera
Connect the video RCA of the after-market rear-view camera to female
RCA connector R-CAM IN of Interface-box C1C-M01.
Connect the green wire of the 4pin cable to the camera power supply (+12V max. 1A)
of the after-market rear-view camera and the grey wire to ground of the vehicle. The
green wire is high (+12V max. 1A) when reverse gear is engaged. The white wire of
the 4pin cable is not connected and has to be isolated. In some cases it is possible
that the automatic switching does not work. In this case connect the white wire to
the reverse gear light (+12V).
Connect pin 2 of chamber C of the Quadlock to
reverse gear light (+12V) (loose white cable
included in harness C1C-RNSE).
Note:
Only compatible with NTSC-cameras.
Automatic switching on reverse gear from OEM
mode to camera input only works after coding
the head-unit per diagnosis computer (Only
possible on RNS-E with minimum software 550
and till year 2010).
If coding is done by diagnosis PC, code rear-view camera to value 1 in channel 04,
controller 56. After coding the vehicles needs to be locked for at least 66 minutes to
reach general sleep mode.
