20 Instruction manual WMi4001
Please keep this instruction manual for future reference
For safety reasons, in some wash cycle phases, the door can be opened only if the level of the
water is below its lower edge and if the temperature is less than 45°C. If these conditions are
met, wait for the
DOOR LOCKED
light to switch off before opening the door.
Press the
START/PAUSE
button again to re-start the programme from the point it had been
paused at.
C A N C E L L I N G T H E P R O G R A M M E
To cancel the programme, set the selector to the
OFF
position.
Wait 2 minutes until the safety device unlocks the door.
D E L AY S TA RT B U T TO N
This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to
24 hours.
To delay the start use the following procedure:
› Select the required programme.
› Press the delay start button once to activate it (h00 appears on the display) and then press
it again to set a 1 hour delay (h01 appears on the display). The pre-set delay increases by
1 hour each time the button is pressed, until h24 appears on the display, at which point
pressing the button again will reset the delay start to zero.
› Confirm by pressing the
START/PAUSE
button. The delay countdown will begin and when it
has finished the programme will start automatically.
It is possible to cancel the delay start by turning the programme selector to
OFF
.
If there is any break in the power supply while the machine is operating, a special memory
stores the selected programme and, when the power is restored, it continues where it left
OFF
.
The function buttons should be selected before pressing the
START/PAUSE
button.
F U N C T I O N B U T TO N
This button allows you to choose between three different functions:
P R E - WA S H I N G
This function provides a prewash and is particularly useful for heavily soiled loads.
