Caple WMI3005, Service Manual

Page: 37 / 38

Error
Code
Define Unit Action Causes Explanation Notes
Low Water Pressure from House Supply
If the washer fills very slowly, the water pressure from the house might be too
low. If the water inlet valve isn't leaking and there are no other symptoms this
problem does not need to be corrected.
Water inlet hose
Make sure that water faucet is turned on and that the screens on the hoses are
not restricted.
Water inlet valve (The voltage on the water
inlet valve is normal) .If the water pressure is good, try cleaning the screens inside the water inlet
valve hose connection ports. If those are clean replace the water inlet valve
Water level sensor or control switch (No
voltage on the water inlet valve)
A water lever control switch controls how much water enters the washing
machine by PCB. If the water level control switch is defective, or more
commonly, if the small air pipe attached to the air bell restricted, The switch will
not be able to close the electrical contacts to the washer fill valve.CHECK THE
AIR PIPE CHECK THE WATER LEVERL SENSORCHECK THE PCB and the
inner wire between PCB and the sensor
Restart Some time just restart the unit can solve the problem.
Water inlet valve (The voltage on the water
inlet valve is normal)
If the washer is overflowing, the water inlet valve has failed. Replace it.
Water level sensor or control switch (No
voltage on the water inlet valve)
A water lever control switch controls how much water enters the washing
machine by PCB. If the water level control switch is defective, or more
commonly, if the small air pipe attached to the air bell restricted, The switch will
not be able to close the electrical contacts to the washer fill valve.
CHECK THE AIR PIPE
CHECK THE WATER LEVERL SENSOR
CHECK THE PCB and the inner wire between PCB and the sensor
E20 Pump open circuit
Unit will close valve and
stop with Error code
display
Pump Check the pump or the and the inner wire of the pump
Drain Hose
If the washer won't drain water check the drain hose. Be sure the hose did not
get kinked behind the washer. Also, remove the hose from the pump and check
it for obstructions.
Pump
If the washer won't drain water the drain pump might be defective. It's also
common for a small sock or other article of clothing to get caught in the drain
pump or in the drain hose. Check both for an obstruction before replacing the
pump.
PCB Check PCB
Error code For Front-Load Washer
In 7 minutes, the water level
doesn’t change with valves open
Overflowing
Washer Won‘t Drain. Or drain
timeout
Unit will close Pump
and stop with Error
code display
E21
Unit will close valve and
stop with Error code
display
E10
Unit will close valve and
stop with Error code
display
E12