Caple WMI3005, Service Manual

Page: 38 / 38

Error
Code
Define Unit Action Causes Explanation Notes
Error code For Front-Load Washer
Door Lock
If the door won‘t latch, the door lock assembly might be defective. If the door
won’t latch ,check the door to see if the door is closed before replace it.
PCB
If the washer door won‘t unlock the problem might be the main control board.
This is not common. Check the inner wire between the PCB and the door lock.
Door Lock
If the door won‘ unlock, the door lock assembly might be defective. If the door
won’t latch ,check the door to see if the door is closed before replace it.
PCB
If the washer door won't unlock the problem might be the main control board.
This is not common. Check the inner wire between the PCB and the door lock.
E33 Water level sensor error
Unit will close valve and
stop with Error code
display
Water level sensor or control switch (No
voltage on the water inlet valve)
E33 means the unit can’t detect the Signal of Water level sensor.
CHECK THE WATER LEVERL SENSOR
CHECK THE PCB and the inner wire between PCB and the sensor
E40 Memory chip error / memory chip broken Memory chip of the PCB broken, just replace the PCB
E70 Button get stuck / Button get stuck Re-assemble the control panel.
E60 The motor don’t drive for 5 times The motor don’t drive /
Check the motor communicate wire
Check the PCB and the motor
E61
The PCB can’t get speed transmit
signal when the motor drive The speed don’t
transmit signal
/
Check the motor communicate wire
Check the PCB and the motor
E62 Triac get broken
The speed don’t
transmit signal
abnormality
/
Check the motor communicate wire
Check the PCB and the motor
E64 (Transducer Error) Transducer Error Transducer Error Check the wire connect before replacing the Transducer
E50-E5X
（ X means different letter or
number ）
/ Transducer Error Check the wire connect before replacing the Transducer
E37
In the drying process, the
temperature sensor at the air outlet
is wrong
/
Temperature sensor Check the inner wire before replacing the Temperature sensor
（ Outlet and inlet are
different with different
model
）
E38
In the drying process, the
temperature sensor at the air
intake is wrong
/
Temperature sensor Check the inner wire before replacing the Temperature sensor
（ Outlet and inlet are
different with different
model
）
Drying heater
Push the red part of the temperature sensor before checking.
Check the inner wire on PCB, Fan motor heater, temperature sensor.
Check the heater resistance
（ should be a certain value ）
Lint on fan wheel and condenser
Check and clean the lint on fan wheel.
Check the lint in the air condenser.
Washer Door Won't unlock
Drying heater open E3A Drying heater open
E31
Washer Door Won't Lock
E30 Try 6 times ， not lock